Pay in 4 interest-free payments of $25.79 Learn more
Ships within 48 hours · Estimated delivery Oct 22 - Oct 27
A generous spraying on the newly exposed section of timber is recommended
Overall : 220mm Height x 90mm Width x 65mm Depth
This fitting will work with horizontal galvanised pipe (tube) of an outside diameter of approximately 34mm
IMPORTANT - Please Read: These products are hand carved in the Philippines
Sloping Floor Flange (30-45 degrees) for 42mm Galv Pipe D5VD02 A generous spraying on theWhere would you normally use this galvanised pipe fitting? The 251 Slope Base Flange (30 degree to 45 degree) is a base flange for sloping sites, adjustable from 30 degree to 45 degree. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright
