26-8M-30 Timing Pulley with Taper Bore 26 Teeth 8mm Pitch 30mm Wide Tags Hold on to the T-grip

Hold on to the T-grip and at the same time use the jaw wrench to tighten the nuts above the cross-beam until the component has been loosened from its position

and ensure a firm footing during extraction

15-3 Separators

Grease 9000 rpm

26-8M-30 Timing Pulley with Taper Bore 26 Teeth 8mm Pitch 30mm Wide Tags Hold on to the T-gripThese pulleys have equally spaced grooves machined in to the outside diameter, to give correct meshing with the timing belts teeth. The pulley grooves are of a special design to give this correct meshing of the timing belt teeth with minimal friction. All pulleys manufactured have correct minimum meshing tolerances built in and the pitch diameter is always larger than the outsside diameter. Product Description: Number of teeth: 26 Pulley type: 4 Bush